Laser cutting machine processing sheet metal burr solution:

1, must be equipped with air compressor, the use of auxiliary gas to cut.

The purity of the gas is higher, you can change a better quality gas supplier, the purity of the gas is very important, do not use the cylinder gas, because after two filling, the purity is not good, but also waste gas.

Such as laser cutting stainless steel, it is recommended that the auxiliary gas use nitrogen, nitrogen is a flame retardant gas, laser processing nitrogen not only to prevent the laser cutting burst point phenomenon, but also the heated end face will not be instant oxidation, cutting the end face will be more smooth and bright. The auxiliary gas should be adjusted to 12-15 kg pressure, and the nitrogen under this pressure will not completely prevent combustion, but also can quickly blow away waste to remove burrs.

2, find a professional operator to debug the metal laser cutting machine parameters, until normal, you can successfully complete the cutting operation of the metal laser cutting machine.

Some parameter setting factors of the laser cutting machine will also affect the appearance of slag, resulting in the burr of the metal laser cutting machine, so the cutting parameters should be adjusted to the best, the air pressure flow focal length cutting speed, after many adjustments, the parameters provided by the machine are not cut out of the exquisite workpiece.

Laser cutting machine is a precision machine, the operation is also a fine work, often a data error will cause its work operation is not normal, so in the work to be strict and fine, reduce and avoid errors. Equipment + gas + parameters, adjusted to the best, the cut out of the workpiece is no burr, so that the cutting of the laser cutting machine becomes more quality.